These wires are usually short and won’t be reconnected until you are about to install the new stereo. The antenna wire is much thicker with a metal head and can be connected separately before you install the stereo.Use the diagrams to properly match each with its appropriate wire from the car. The rest of the harness wires are for the speakers.The 12 volt constant power wire is usually yellow or blue, though it may be a number of colors coming from the car.If there is no ground wire, you can secure the ground cable to bare metal in the body of the car to serve as a ground. The ground wire for the stereo will be black, as will its corresponding wire from the car.The power wire coming from the stereo is usually red, and likely will connect to a red wire from the car.Most car stereos will require the following connections: X Research source Use the repair manual for your car or locate a wiring diagram for your car online to aid in your efforts to identify each wire. Once the parking brake lock-out feature is installed, the owner/user must not attempt to disrupt/neutralize the parking brake lock-out feature by (a) partially engaging the parking brake and/or (b) purchasing/using any device or unit designed to send necessary brake signals to the unit. Without an adaptor, you will need to cut the wires on the back of the car’s harness clip, but do so one at a time as you connect them to their corresponding wire on the stereo to prevent confusion. If you are not using a wiring harness clip adaptor, you will need to identify the wires coming out of the stereo, as well as those coming out of the car. Disconnecting the battery will prevent you from doing damage to the electrical system as well as protect you from shocks.Nothing electronic should work with the battery disconnected. To be sure the battery is disconnected, check to see if the lights come on in the cabin of the car.Web view the manual for the dual mcp1337btb here, for free. You do not need to remove the battery or disconnect the cable from the positive terminal. A Wiring Diagram Will Reveal You Where The Cables Need To Be Linked, Removing The Need For Guesswork.Tuck the cable down to the side of the battery so that it can’t come back into contact with the terminal. You will not need to remove the bolt entirely, instead simply loosen it enough to pull the cable off of the terminal. Once you locate the battery, use a hand or socket wrench to loosen the black cable from the negative terminal on the battery. If you aren’t sure where to locate the battery in your vehicle, refer to your owner’s manual most car batteries can be found under the hood, but some are kept in the trunk. Because you will be working on the electrical system of your car, it’s important to disconnect the battery before you get started.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |